Rating
Homemade RC boat (Instructions)
Some Instructions for building my homemade RC boat
New Electric Remote Control Racing Viper Boat
25 Responses to “Homemade RC boat (Instructions)”
Have A Question?
Are you looking for something but can not find it, or have a question for us? We would love to help you. Just fill out the form below and we will get back to you as soon as possible.
Which materials are overlaid ship?
me?, I’m german
are you filipino?
HI , do i need 2 speed controlers if i wont to put 2 motors inside my boat,and if not which speed controler did u used
hey dude ..
where can i buy remote controller..
here at rizal…
?
ahahaha..
lolz..
xD read under my other videos
what kind of wood did you use?
ye , thx i almost finished building skeleton of it . it is looking very nice , ill send u pictures when it is finished. thx again
Thanks
By coating i meant the white enamel/paint. I’m into planes and there we use oracover but i was wondering what is the current coverage for the boats folks.
hey, try to make a drawing of it, I’m sorry, but I havnt got any other messurements or something else, it was scratch built… Maybe you can make a first model out of carton to get a real picture of it.
You can change everything you want to get the whole shape perfectly.. The messurements in the video are just unexactly taken from the finished thing. It just should be a uncouthly examble how it looks like…. good luck!
the “coating” is the balsawood. the rips are made out of stronger wood.. and it is painted with white acryl-resin paint.
Hi, i am tryingto build this boat but there are some measurments missing, could u link me blueprints or something so i can continue building
Very pretty and elaborate shape! Is it balsa wood? And what is the coating over it?
hi, I built it at first to get a good steering and a straight driving but I had to remove it, because it wasnt good to control, it drove too big curves…
you should make just a little fin under it…
and I think it should be possible with fibre glass, or didnt I get the question? and a nitro engine.. maybe you can build it bigger than I did..
alrite mate hope you can help this well be my first rc boat, on this vid at about 1min 40 sec you see the bottom of the boat and i noticed on the back half of the bottom there is a channel in the middle or is it the pic and if it is a channel how does the measurements work on this. and i kno people have asked you about scaling it down but is it ok to scale up as i wont to fibreglass inside this hull and then fit to nitro engines as nitro is more my thing thank you and hope you can help
did you put something else on the wood?
the whole thing is about 75 cm long, 16 cm wide and 7 high.
hiya MFCLord, i was just wondering, what are the actul dimension for the boat you have built, so i can have a rough sketch of what you have built, thank you
hey,… i dont know if the hull wont be too deep in water because of the weight.. you should try it with any other thing with ca. the same size to compare it.
yo hi mfclord i have some balsa wood so can i make a smaller version with the same motor and battery like you said its 75cm long can i make it 37.5 cm long.
excellent a master model maker!!!!!!!!!.
I like this kind of scratch buildiing – nobody seems to do it much anymore
did u coat the boat with something
does it drive good
hey, what did you use to waterproof the outside where can i buy it:)
thanks