Fast RC Boat Rigger Arrow wind NQD

NQD Arrow wind modified Brushless 1700 kv Li-po 4s 2200 mah Octura x438

Balaenoptera Musculus Radio Remote Control Racing Boat

24 Responses to “Fast RC Boat Rigger Arrow wind NQD”

  1. MrCraigian67 says:

    WELL DONE ,thanx for sharing your vid,cheers

  2. nungmekha says:

    No,i don’t

  3. nookiemookiedookie says:

    do you use a water jacket for your outrunner?

  4. nungmekha says:

    about 800-950g.cheers

  5. Dellz88inside says:

    Total Weight?

  6. nungmekha says:

    Motor outrunner 1700kv i got it on eBay and esc 70 A from eBay as well

  7. 01silky1 says:

    how did you get it to so fast
    ie what motor and esc did you use

  8. robloxfan202 says:

    holy shit nuggets!

  9. nungmekha says:

    Yes ofcoz,have a look in describtion

  10. PhatChance7111 says:

    does this have upgrades???

  11. jacouette says:

    trop bien ton rigger !

  12. nungmekha says:

    Si si j’ai modifié,regardez dans plus d’info en haut à droite

  13. Demonacuda says:

    Vraiment rapide le Arrow Wind.
    Jvè m’enprendre un!!!
    Trop bien mais vous l’avez pas modifié celui la? :-)
    :-O

  14. Stuff150 says:

    thx, that is what i tried to do but i had to cut the bar that was holding the pontunes to get reciver out instead. so i will probably just buy a boat

  15. nungmekha says:

    Hi,i undo all the screws under the hull and separate the 2 parts.then install the ESC and receiver right on the head,and then seal with silicone on the hull then close.behind i have only motor and servo and still have big spaces to fit li-po until 6 cells!

  16. Stuff150 says:

    How did u do that? i tried to do the same thing wiht my castle creations system and futuba receive and they would not fit, and the boat wouldn’t float either.

  17. nungmekha says:

    hi,i took everything inside out,i keep only hull,now run with Feigao 380s 4934kv got very fast

  18. nitrocloud says:

    Hi, Great mod, can you tell me how you wired this up ? can you use the output from the exsisting reciver to the ESC ? or did you fit all new electronics ? did you keep the stock stearing servo ? Thanks

  19. nungmekha says:

    i think it go around 5-6Km/h,it was very very slow.if you want to make it fast,you have to modify.if you want cheap fast boat out of the box you can check out EP RACING BOAT(made in chaina)and put 8 cell Ni-xx 3000mAh up.good fun

  20. tmaxxcowboy says:

    how fast will it go out of the box

  21. nungmekha says:

    only the boat (new in box)on eBay i paid about 21€.then brushless motor,esc,props,flex drive,Batt li-po,radio etc….quite expensive

  22. tmaxxcowboy says:

    how much does that cost

  23. 2FRIEND3 says:

    good friend
    kaew

  24. nungmekha says:

    just motor Brushless 1700kv,ESC Dynam 70A,Li-po 4s 2200mAh,Octura X438.thats it

Have A Question?

Are you looking for something but can not find it, or have a question for us? We would love to help you. Just fill out the form below and we will get back to you as soon as possible.

Other Resources:
Garmin Approach G5 Review | truck dump bed | Auto Glass Repair Toronto | window film | Ultimate WoW guide review
best man speeches | Power Of Attorney | rooms to rent | GPS Comparison | Piano For All